The Val-Tex 40-70 comes equipped with a modified 8540-A1 High Pressure Pump. The service
instructions enclosed provide a general guide as to safety requirements, disassembly,
reassembly and parts. Please consult Val-Tex when reordering replacement parts. Standard
Alemite parts may not apply.
40-70 Requirements
To obtain 8000 PSI output requires 150 PSI of air at 6 CFM.
Air Regulator, moisture separator and oiler (not included) are recommended on the air supply line
to prolong the life of the pump.
Before Operating the 40-70
1. Connect lube sealant hose assembly to the motor. Check all threaded connections to ensure
the hose assembly is properly tightened.
2. To Pump Lube Sealant: (NOTE: See the instructions for use of the 40-70 pail adapter prior to
inserting the pail.)
A. Open the pail of lube sealant and place it in the bottom of the canister.
B. Insert the follower plate into the lube sealant can.
C. Clamp the canister lid down by tightening down the knurled nuts on the three thumb
screws.
D. Secure the latches by engaging them into the strike.
3. To Pump Valve Flush: (NOTE: See the instructions for use of the 40-70 pail adapter prior to
inserting the pail.)
A. Open the pail of Valve Flush and place it in the bottom of the canister.
B. Remove the follower plate from the pump tube before use.
1) Remove the snap ring that secures the follower plate to the bottom of the pump
tube.
2) Remove the follower plate from the pump tube.
C. Insert the pump tube into the Valve Flush can.
D. Clamp the canister lid down by tightening down the knurled nuts on the three thumb
screws.
E. Secure the latches by engaging them into the strike.
4. Connect the air hose to the pump

VAL-TEX 40-70ע֬ǹ
VAL-TEX 5-70ע֬ǹ
VAL-TEX 10-70ע֬ǹ
VAL-TEX QS-5000ע֬ǹ
VAL-TEX QS-5000-Cע֬ǹ
VAL-TEX 1000-31ÊÖ¶¯ÂÝÐýע֬ǹ
VAL-TEX 1400¸ßѹҺѹÊÖ¶¯×¢Ö¬Ç¹