无锡工业环氧地坪价格是多少 400-0709-910(请拨打400-0709-910电话，永坚地坪公司)

专业生产金刚砂耐磨地坪一般是由冶炼的金刚砂及特殊添加剂与标准高标号水泥和其它高科技化学材料生产合成。金刚砂耐磨地坪经与新浇混凝土基面整体固化后，具有表面硬度高、密度大、耐磨、不生灰尘、不易剥离形成一密实平整、无接缝、无孔面层。金刚砂耐磨地坪耐磨性、耐冲击性、强度是普遍混凝土(C30)地面的数倍以上，而且其坚硬、密实的表面可抵抗油脂和润滑油。
　　金刚砂耐磨地坪摒弃了传统的混凝土基层与面层分开施工的做法，从而了因基层与面层结合不良而导致裂缝 和空鼓的质量通病，金刚砂耐磨材料简化了工序，缩短了施工周期，节约人工费用，经济、适用、范围广等优点在工厂、仓库、跑道、 码头等工程中得到越来越广泛的应用。
　　金刚砂耐磨地坪对找平层的要求：
　　金刚砂耐磨地坪对有钢筋要求的地台，应按设计设置钢筋或铺设网眼孔径为5㎝×5㎝的钢网，钢筋或钢网下面设置垫块；
　　在浇注混凝土作业时，需用震动桥或水平式震动器对混凝土进行震实作业；
　　由于地面进行分仓作业，应在每仓边缘架设标高钢模或木模板，以确保表面水平度；
　　注要分仓按序进行，以保证整体地面水平硬化层的机器作业；
　　金刚砂耐磨地坪工前应将所需施工地面均匀淋洒水泥油，以防止找平层起壳；
　　使用较重的钢制长辊对混凝土进行辗压，使地面达到初平，并用胶管去除多余泌水后，便可交予我方进行硬化剂施工。 金硅地生成的混凝土液态硬化剂是通过充分渗透，其成分能迅速地与混凝土中的游离钙发生化学反应，增加结构的致密性，使得混凝土表层形成一个坚如磬石的坚固实体，极大地提高混凝土结构表层的强度和耐磨性，从而得到封闭、坚固、耐磨、不起尘、抗水和大多数工业化学品侵蚀的表面。熟化封堵，不会像表面涂层随着使用而磨损，本品因为锁住孔隙，会使混凝土变得愈来愈硬，封堵性愈来愈好。

金硅地混凝土液体硬化剂使用方法

1.在正式使用前，建议针对特定地面先进行现场小面积试验，在确认使用效果和用量后再大面积使用。
（施用前请搅拌均匀）。
2.在清理干净的混凝土表面上，喷洒或滚涂欧佳牌混凝土表面增强剂，（一般一遍即可，第二遍视遍效果而定,时间在遍施工后2-12小时之间），维持饱和湿润状态 10-20分钟，以利更多成份进入混凝土内部。Specializing in the production carborundum wearable Floor is generally made of carborundum smelting and special additives and standard grade cement and other high-tech production of synthetic chemical materials. Emery wear floor after pouring the concrete surface with the new overall curing, high surface hardness, density, wearable, not raw dirt, easy to peel the formation of a dense smooth, seamless, nonporous surface. Carborundum wearable Floor abrasion resistance, impact resistance, strength is several times more than common concrete (C30) ground, and its hard, dense surface that is resistant grease and lubricants.
Carborundum wearable Floor abandon the traditional concrete base and surface construction of separate practices, thereby eliminating the grassroots and the surface layer due to bad combination resulting in cracks and hollowing quality defects, Emery wear material simplify the process and shorten the construction cycle, saving labor costs, economical, practical, wide range of advantages to be more widely used in factories, warehouses, runways, terminals and other projects.
Carborundum wearable Floor screed on request:
Carborundum wearable Floor reinforcement required to have ground units, according to the design or paved with reinforced mesh aperture of 5 cm × 5 cm of steel mesh, steel or steel mesh pad set below;
When pouring concrete work, bridge or horizontal vibration required Vibrators real shock for concrete operations;
Since the ground operation sub-positions, should erect steel or wooden template level positions in each edge, to ensure that the level of the surface;
Note To binned performed sequentially, in order to ensure that the machine work hardened layer overall level of the ground;
Carborundum wearable Floor ground workers should be required before construction even showered cement oil to prevent screed from the shell;
After using heavier steel rolling long roll of concrete, so that the ground level reached at the beginning, and with a hose to remove excess bleeding, can be handed over to our side hardener construction. Gold silicon to generate a liquid concrete hardener is through the full penetration, the active ingredient can occur rapidly with concrete free calcium chemical reaction, increasing the density of the structure, so that the concrete surface to form a hard as chime stone strong entity, pole the surface of the concrete structure greatly improves strength and wear resistance, resulting in permanent closure, strong, wear-resistant, can not afford to dust, anti-water and most industrial chemicals erosion surface. Maturation block, not as a surface coating with use and wear, this product permanently locked because the pores will become increasingly hard concrete, sealing of getting better and better.
 
   Gold silicon liquid hardener to the concrete method
 
     1. Before the official use, it is recommended to test a small area site-specific ground, confirming the use of effects and dosage before large-scale use.
(Please stir before application).
     2. In the clean concrete surface, spray or roller Ojai brand concrete surface enhancer (general it again, the second time, as the first pass effect may be, in the 2-12 hour period after the first pass construction among the best), to maintain the saturated wet for 10-20 minutes, in order to facilitate more effective ingredients into the concrete.

资讯来源：<联系电话:400-0709-910>